Install tension strut on shock tower

NOTE: Description is for left component only. Procedure on the right side is identical.

Install tension strut (3) on the shock tower.
Replace the screw (1).
Parts: Screw
Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Tension strut on firewall
M10x25 screw Replace screw.	Joining torque	56 Nm
	Angle of rotation	90°

G14316532

Courtesy of BMW OF NORTH AMERICA, INC.

Replace the screw (2).
Parts: Screw
Tighten down screw (2).

TIGHTENING TORQUES SPECIFICATION

Tension strut to shock tower
Torx bolt Replace screw.	Joining torque	56 Nm
	Angle of rotation	90°

→ Repair thread on the spring bolt

Repair the damaged thread with a Helicoil thread insert.

CONSUMABLE DESCRIPTION

Helicoil thread insert

M10x25 mm

33 30 6 782 756

Follow-up work

Install windshield panel COVER .
Install left and right WIPER ARM .
Install the rear right engine compartment COVER .
Install the rear left engine compartment COVER .