Installing the bottom automatic air flap control
- Connect the plug connection.
- Feed in the bottom automatic air flap control (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Air flap control/Brake ventilation duct | ||
| Oval-head screw | Tightening torque | 4.0 Nm |
→ Installing the ACC sensor with holder
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Attach the ACC sensor (3) with the holder and correctly position it.
- Connect connectors (1) and lock.
- Fasten the cable latches at the marked points.
- Tighten the screws (2).
TIGHTENING TORQUES SPECIFICATION
| Sensor bracket/ACC sensor | ||
| Screw | Tightening torque | 8 Nm |
→ Adjusting the ACC sensor
NOTE:
TECHNICAL INFORMATION
Notes on the adjustment of the ACC sensor are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: NOTES ON ADJUSTING THE ACC SENSOR .
Notes on the adjustment of the ACC sensor are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: NOTES ON ADJUSTING THE ACC SENSOR .
- Adjust ACC sensor.
Follow-up work
- Install front bumper COVER .
- Partly install the front sections of both front wheel arch COVERS .
- Partially install both front wheel arch TRIMS .
- Install front ORNAMENTAL GRILLE .