Install bumper cover upper section at front

NOTE: Perform the steps on the left and right side.

• Slip fog light support (2) into guide (4) of bumper cover upper section and clip into detents (3).
• Clip in the expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the left and right side.
• Clip bumper brackets (2) into detents (3).
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bumper bracket, side front
  Screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert vehicle wiring harness (1) into guides of bumper cover upper section.

Courtesy of BMW OF NORTH AMERICA, INC.