Installing the transmission oil cooler
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Feed in and install the transmission oil cooler (1).
- Tighten screw (2) by hand.
- Tighten screw (1) by hand.
- Tighten screw (2) by hand.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Transmission oil cooler to crankcase | ||
| M6 | Tightening torque | 8 Nm |
- Tighten the screws (3).
TIGHTENING TORQUES SPECIFICATION
| Transmission oil cooler to crankcase | ||
| M6 | Tightening torque | 8 Nm |
- Tighten the screws (2).
TIGHTENING TORQUES SPECIFICATION
| Transmission oil cooler to crankcase | ||
| M6 | Tightening torque | 8 Nm |
- Secure clamps (1).
- Connect the transmission oil lines (2).
- Press the locking mechanism (1) in the arrow direction and lock the transmission oil lines (2).
- Connect and lock the coolant line (2).
Coolant line (2) must engage audibly.
- Connect and lock the coolant line (1).
Coolant line (1) must engage audibly.
Follow-up work
- Connect the radiator COOLANT LINE .
- Install the front bottom right wheel arch COVER .
- Install the center UNDERBODY PROTECTION .
- Install the front UNDERBODY PROTECTION .
- Fill the HIGH-TEMPERATURE COOLING SYSTEM with the vacuum fill equipment.
- Vent the HIGH-TEMPERATURE COOLANT SYSTEM .
- Check the HIGH-TEMPERATURE COOLING SYSTEM for water tightness.
- Check/top up the automatic transmission OIL LEVEL .
- Install rear UNDERBODY PROTECTION .