Install the coolant expansion tank for the low-temperature coolant circuit
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
Immobilization period-long fill of coolant!
Do not reuse used coolant.
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be emptied and refilled.
In the case of other removal work involving the draining of part quantities of coolant, the coolant level must be topped up with new coolant.
- Guide in the coolant expansion tank for the low temperature coolant circuit.
- Connect and audibly lock coolant line (1).
- Connect and audibly lock coolant line (2).
- Mount coolant expansion tank (2) of the low temperature coolant circuit to the coolant expansion tank of the high-temperature coolant circuit.
- Lock the lock (1).
- Loosen sealing cap (1).NOTE: TECHNICAL INFORMATION
Follow NOTES for repair work on the cooling system. For additional information see: Main group 17 (17 00) Notes for repair work on the cooling system - Top up coolant to maximum mark.
- Close sealing cap (1).
Follow-up work
- Install the front left bottom wheel arch COVER .
- Install the front UNDERBODY PROTECTION .