Removing the mechatronics
Preliminary work
- Deactivate the 48 v ELECTRICAL SYSTEM .
- Disconnect all battery GROUND LEADS .
- Remove rear UNDERBODY PROTECTION .
- Remove transmission OIL PAN (all wheel drive vehicle) (GA8HP50Z, GA8HP51Z).
- Remove the oil volume RESERVOIR (GA8HP50Z, GA8HP51Z, GA8HP75Z, GA8HP76Z, GA8HP95Z).
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
- Pull the selector shaft tappet (1) downward with the special tool 2 355 850 (3) in the direction of the arrow.
- Install the special tool 2 355 850
(2) between the selector shaft tappet (1) and transmission housing in arrow direction.
- Turn connector (1) in arrow direction and detach.
- Insert special tool 0 494 213 (24 2 390)
in sealing sleeve (1).
- Release the screw (1) and unlock the sealing sleeve with the slide (2) in arrow direction.
- Observe the installation position of the sealing sleeve (1).
The sealing sleeve (1) must be installed in the same position during installation.
- Pull out the sealing sleeve (1) in direction of the arrow.
- Release the screws from the mechatronics in the marked area (1).
- Install the special tool 0 496 715 (24 1 430) in the marked area (1).
- Tighten the wing nuts (1).
- Loosen screws (2).NOTE: TECHNICAL INFORMATION
The tappet on the output RPM sensor may break off during removal or installation.NOTE: TECHNICAL INFORMATION
Note the original installation position of the output RPM sensor.
Observe the correct installation position when installing the output RPM sensor. - Carefully pull the output RPM sensor (3) out of the housing and insert it in the recess on the module.
- Loosen screws (1).
- Remove the wing nuts of special tool 0 496 715 (24 1 430)
.NOTE: TECHNICAL INFORMATION
Carefully remove mechatronics. - Remove mechatronics.
- Remove pressure pipe (1).