Installing the DME control unit
NOTE:
TECHNICAL INFORMATION
If the DDE control unit or an injector has been replaced, it will also be necessary to carry out injection quantity compensation. The adjustment value (7-character letter code/number code) for the injection quantity compensation is engraved on each injector.
If the DDE control unit or an injector has been replaced, it will also be necessary to carry out injection quantity compensation. The adjustment value (7-character letter code/number code) for the injection quantity compensation is engraved on each injector.
NOTE:
TECHNICAL INFORMATION
Follow instructions for removing and installing control units.
For additional information see: 12 00... NOTES on removal and installation of control units
Follow instructions for removing and installing control units.
For additional information see: 12 00... NOTES on removal and installation of control units
NOTE:
TECHNICAL INFORMATION
Control unit must be programed after it is replaced.
For ADDITIONAL INFORMATION see: 61 00... Programming/coding control unit(s)
Control unit must be programed after it is replaced.
For ADDITIONAL INFORMATION see: 61 00... Programming/coding control unit(s)
NOTE:
TECHNICAL INFORMATION
Disconnecting control units may cause fault code entries and functional limitations. Fault code entries must be read out and deleted if necessary.
Disconnecting control units may cause fault code entries and functional limitations. Fault code entries must be read out and deleted if necessary.
- Feed in and install DME control unit (1).
The locks (arrows) must engage audibly.
- Connect connectors (1) and lock.
All connectors (1) must engage audibly.
- Feed in the cover (1) into the guide and install it.
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to IF THE DME CONTROL UNIT IS REPLACED: PROGRAM/CODE DME CONTROL UNIT .