Checking the end clearance of the new piston rings

Prerequisite

Cylinder path is cleaned. Cylinder was measured and is within the permissible tolerances.

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Insert new piston rings (1) in the cylinder to be measured and turn by 90° in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Position all new piston rings (1) one after the other in the cylinder path below the upper dead center (arrow).

Courtesy of BMW OF NORTH AMERICA, INC.
Press all the new piston rings in consecutive order using piston (1) up to the last annular groove (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

Check
Measure the end clearance of all the piston rings in consecutive order with a feeler gauge as shown.

Determining the correct set of the piston rings (see the applicable BMW Parts Catalog):

Courtesy of BMW OF NORTH AMERICA, INC.

Engine	Set of piston rings	Pistons	End clearance of the upper piston rings (plain rectangular compression ring)	End clearance of the piston rings in the center (taper faced piston ring)
B38M1 ECE	8 693 017	8 678 931	0.2 - 0.3 mm	0.4 - 0.6 mm
B38M1 ECE	8 693 017	9 494 399	0.2 - 0.3 mm	0.4 - 0.6 mm
B48M1 ECE	8 693 017	8 678 931	0.2 - 0.3 mm	0.4 - 0.6 mm
B48M1 ECE	8 693 017	9 494 399	0.2 - 0.3 mm	0.4 - 0.6 mm
B38M1 CN	8 693 017	8 678 931	0.2 - 0.3 mm	0.4 - 0.6 mm
B38M1 CN	9 847 276	8 681 079	0.2 - 0.3 mm	0.4 - 0.6 mm
B48M1 CN	8 693 017	8 678 931	0.2 - 0.3 mm	0.4 - 0.6 mm
B48M1 CN	9 847 276	8 681 079	0.2 - 0.3 mm	0.2 - 0.3 mm
B48O1 ECE+CN	8 693 017	8 678 934	0.2 - 0.3 mm	0.4 - 0.6 mm
B48T1 ECE+CN	9 846 014	9 488 343	0.2 - 0.3 mm	0.2 - 0.3 mm
B58M1	9 847 276	8 681 079	0.2 - 0.3 mm	0.2 - 0.3 mm
B58O1	9 693 017	8 678 934	0.2 - 0.3 mm	0.4 - 0.6 mm

Desired state