Install the acoustic cover for the oil sump

• Guide in the acoustic cover (2) towards the front at top and position.
• Fasten expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten expanding rivet (1).
• Check the Christmas tree clip (2) for damage, replace if necessary.

Parts:  Christmas Tree clip

Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten expanding rivet (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the connector (1).
• Make sure the connector (1) engages audibly.
• Insert and install the positive battery cable (3).
• Secure positive battery cable (3) at the clamp (4).
• Tighten the nut (2) hand-tight.

Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly  attach the positive battery cable (1) to the anti-twist lock (2).
• Tighten nut (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to RAISING THE FRONT AXLE SUPPORT AND FASTEN IT .
• Refer to LOWERING THE ENGINE AND DETACHING THE ENGINE BRIDGE .
• Refer to FASTENING THE ENGINE SUPPORT BRACKETS TO THE ENGINE MOUNTS ON THE LEFT AND RIGHT .
• Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
• Refer to FASTENING ELECTRIC COOLANT PUMP AND COOLANT HOSES TO THE FRONT AXLE SUPPORT .
• Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
• Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
• Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
• Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
• Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER .
• Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
• Refer to INSTALLING FRONT WHEEL ARCH TRIM .
• Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING COVER ON EXHAUST SYSTEM .
• Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING FUEL DELIVERY LINE .
• Refer to INSTALLING ALL IGNITION COILS .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE COWL UPPER PART .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
• Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
• Refer to INSTALLING BATTERY COVER IN TRUNK .
• Refer to CONNECTING THE NEGATIVE BATTERY CABLE (12 V BATTERY) .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to INSTALLING FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .