Removing the vibration damper
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Remove rear UNDERBODY PROTECTION .
- Remove the center UNDERBODY PROTECTION .
- Remove STARTER MOTOR .
- Remove the ACOUSTIC COVER .
- Remove the top right and left engine compartment COVER .
- Remove front CROSS CONNECTION .
- Remove the rear top CROSS CONNECTION .
- Remove the FAN COWL .
- Remove the alternator DRIVE BELT .
- Position special tool 0 496 595 (11 6 130) and fasten with screw (1).
- Slide counter support on screw (2) in direction of flywheel and turn the engine on the vibration damper until the gearing (3) can reach into the flywheel.
Tighten down screw (2).
- Release screws (1) and remove the vibration damper (2) from the top.