Install bearing bracket
- Coat the O-ring (1) with front axle transmission oil.
- Position the bearing bracket (2) at the engine oil pan.
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Bearing bracket to engine oil pan. | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
Follow-up work
- Refer to REPLACING THE RADIAL SHAFT SEAL OF THE BEARING BRACKET .
- Refer to FASTENING ACOUSTIC COVER ON THE OIL PAN .
- Refer to RAISING THE FRONT AXLE SUPPORT AND FASTEN IT
- Refer to INSTALL RIGHT OUTPUT SHAFT .
- Refer to POSITIONING THE OUTPUT SHAFT, RIGHT, AT THE SWIVEL BEARING .
- Refer to TOPPING UP/CHECKING FRONT AXLE TRANSMISSION OIL .
- Refer to PLACING THE OUTPUT SHAFT, RIGHT, TO THE SIDE .
- Refer to FITTING THE WISHBONE, RIGHT, AT THE SWIVEL BEARING .
- Refer to FASTENING THE RIGHT OUTPUT SHAFT ON THE WHEEL BEARING .
- Refer to SECURING THE TIE ROD TO THE RIGHT ON THE SWIVEL BEARING .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to LOWERING THE ENGINE AND DETACHING THE ENGINE BRIDGE
- Refer to FASTENING THE ENGINE SUPPORT BRACKETS TO THE ENGINE MOUNTS ON THE LEFT AND RIGHT .
- Refer to INSTALLING FUEL DELIVERY LINE
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE COWL UPPER PART .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE COVER PANELS ON THE FRONT AXLE ON THE RIGHT AND LEFT .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY
- Refer to INSTALLING BATTERY COVER IN TRUNK .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE (12 V BATTERY) .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM
- Refer to INSTALLING FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .