Installing the front brake discs (17-inch low brake)

NOTE: TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.

If an arrow 1 is engraved on the brake disc, it must point in the driving direction!
In this case, the left and right brake discs are different!

Courtesy of BMW OF NORTH AMERICA, INC.
Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
Mount brake disc (2).
Position and tighten the screw (1).

Replace screw.

Parts: Screw

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Brake disc to front wheel hub
M8 Replace screw.	Tightening torque	16 Nm

Follow-up work

GREASE the brake pads, the brake anchor plate and the brake caliper with the brake pad paste.
Install front BRAKE PADS .
Install the front brake pad wear SENSOR .
Install the front left and right WHEELS .
COMMISSION/BED (BREAK) IN new brake pads and brake discs.