Remove the rear side window

NOTE: TECHNICAL INFORMATION
Perform window removal using the "spider".
For ADDITIONAL INFORMATION see: 51 31... Window glass removal using "spider"

NOTE: TECHNICAL INFORMATION
The following procedure forms the basis for these repair instructions and must be observed without fail.
For ADDITIONAL INFORMATION see: 51 31... General procedure for disassembly/installation of bonded window glass

NOTE: Description is for left component only. Procedure on the right side is identical.

Preliminary work

Remove the rear window TRIM STRIP .
Remove c-pillar TRIM PANEL .
Remove the D-pillar TRIM PANEL .

NOTE: RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.

Protect working area.
Handle tools and components carefully.

NOTE: TECHNICAL INFORMATION
Secure component against falling.

Disconnect plug connection (1).
NOTE: When removing the side window, make sure that the cable is not damaged.

Courtesy of BMW OF NORTH AMERICA, INC.
Use the cord feeder tool (1) to punch the separating cord (2) as shown through the adhesive bead and insert.

Courtesy of BMW OF NORTH AMERICA, INC.

Guide in separating cord (1) on the separating tool and roll up.
Secure the separating tool (1) as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Install separating cord (1) circumferentially clockwise on the adhesive area of the side window glass behind the seals.
Secure anchor suction cup (2) on the front side window glass as shown.
Secure separating cord (1) with the knurled screw of the anchor suction cup (2).
Separate the side window glass with the Spider.

NOTE: The separating tool must be repositioned repeatedly to prevent damage on the vehicle and the tool!

Courtesy of BMW OF NORTH AMERICA, INC.