Install the left and right bonnet lock
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Attach the cable.
- Feed in the hood lock (3).
- Replace screws (2).
Parts: Screws
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Bonnet lock | ||
| screw Replace screws |
Tightening torque | 8 Nm |
- Connect and lock the plug connections (1).
Activating the 48 V electrical system
Precondition
Ignition is switched off.
NOTE:
RISK OF DAMAGE
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged.
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged.
- Only ever activate the 48 V electrical system when the 48 V battery is fully connected up.
- Raise the battery ground cable (1).
- Remove special tool 2 452 007.
- Release the negative battery cable (2) of the 48-V battery from the attachment.
- Position the negative battery cable (2) of the 48-V battery on the negative battery terminal.
- Tighten the nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Negative battery cable to 48-V battery | ||
| Nut M8 | Tightening torque | 19 Nm |
- Connect the connector (1) of the CAN bus and lock it.
- Clip in the clip (2).
- Activate the 48 V electrical system by closing the hood.
The activation takes place automatically.