Install control unit bracket
- Make sure the control unit bracket (1)
at bottom is fed into the mount (2)
correctly.
- Insert and install the control unit holder (2) in the direction of the arrow.
- Tighten down screws (1)
.TIGHTENING TORQUES SPECIFICATION
Control unit bracket at the shock tower Hexagon screw tightening torque 8 Nm - Connect the connector (1)
with the control unit bracket (2)
and lock it.
The connector (1) must engage audibly.
- Connect the connector (2)
with the control unit bracket (3)
and lock it.
The connector (2) must engage audibly.
- Connect connectors (1)
and lock.
The connector (1) must engage audibly.
- Connect the connector (2)
with the control unit bracket (3)
and lock it.
The connector (2) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Mount the cable bracket (1)
together with the wiring harnesses and lock it audibly.
- Secure clamps (1).
- Secure the wiring harness on the holder (1) .
- Lock the holder (1) audibly.
- Secure the cable with the clamp (2) on the control unit holder.
- Pin up connector (3) and lock audibly.
- Secure the connector (3)
on the control unit holder.
Follow-up work
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING COVER OF THE DME CONTROL UNIT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .