Installing the clean air pipe for cylinders 4-6

Check seal (1) for damage and replace seal (1) as needed.
Parts: Seal

Courtesy of BMW OF NORTH AMERICA, INC.
- Replacing the damaged seal
NOTE: TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.
Remove damaged seal.
Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace gasket.
Parts: Gasket
Install the seal dry without lubricant or mounting agent.
NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.
Thread in seal and install.
Make sure that the seal is installed correctly in the gasket groove (1).
Make sure that the sealing lip (2) is directed to the inside as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in clean air pipe 4-6 (1) and install.

Courtesy of BMW OF NORTH AMERICA, INC.
Detach locks (1) from the holders in the arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in clean air pipe for cylinders 4-6 (2) and connect.

Tighten clamp (1).

TIGHTENING TORQUES SPECIFICATION

Air line to intake filter housing
cl.	tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure that the clamp (1) locks audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work