Installing the tandem brake master cylinder

• Insert the tandem brake master cylinder (1)  into the brake booster.
• Replace nuts (2)  .

  Parts:  Nuts

• Place and tighten nuts (2)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tandem brake master cylinder in the brake booster
  Replace nuts. M8	Tightening torque	27 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• (3)  Fit brake lines and tighten.

Follow-up work 

• Refer to INSTALLING THE EXPANSION TANK .
• Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
• Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to FLUSHING AND VENTING THE REAR AXLE BRAKE CIRCUIT .
• Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
• Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .