Installing the model inscription
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
CAUTION:
Laser beam
.
Injury hazard!
Injury hazard!
- Do not look into the laser beam.
- Park the vehicle and the special tool 2 407 566 on a flat and even surface.
- Mount the laser on the tripod.
- Switch on laser (Position without automatic level).
- Activate laser horizontally and vertically.
- Position the tool behind the vehicle.
Align the vertical laser beam at the edge of the trunk lid with dimension (A=14, 0 cm).
Align the horizontal laser beam at the edge of the trunk lid with dimension (B=5, 0 cm).
- Remove adhesive residue and clean the bonding surface with solvent cleaner R2.
- Detach the liner (protective film) from the adhesive strip of the model inscription.
- Align the model inscription on the laser beam and press onto the trunk lid.