Remount ultrasonic sensors

Preliminary work 

• Refer to REMOVING THE FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
• Refer to REMOVING FLAP IN LUGGAGE COMPARTMENT TRIM PANEL ON RIGHT .
• Refer to REMOVING BOTH TAIL LIGHTS FROM THE SIDE PANEL .
• Refer to REMOVING LEFT AND RIGHT REAR REFLECTORS .
• Refer to REMOVING REAR BUMPER PANEL .
• Refer to REMOVING THE TRIM ON THE REAR BUMPER PANEL .

• Unlock the detents (1).
• Remove the ultrasonic sensor (2) towards the top.
• Remove all other ultrasonic sensors together with the wiring harness.
• Replace the ultrasonic sensors.

  Parts:  Ultrasonic sensors

• Snap all ultrasonic sensors into the bumper.
• Secure wiring harness.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM ON THE REAR BUMPER PANEL .
• Refer to INSTALLING THE REAR BUMPER COVER .
• Refer to INSTALLING THE LEFT AND RIGHT REFLECTOR .
• Refer to INSTALLING BOTH TAIL LIGHTS ON THE SIDE PANEL .
• Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .