Installing the rear tweeter
- Install the tweeter (3) in the speaker holder (5).
- Engage detents (4).
- Insert the cables (2) into all holders.
- Connect the plug connection (1).
- Engage the detent (1) on the speaker holder (3).
- Connect the plug connection (2).
- Rotate the speaker holder (3).
- Insert the speaker holder (4) from above under the shoulder (3).
- Insert the guide pin (2) below the shoulder (3).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Loudspeaker to support/support to dashboard/support to body | ||
| screw | Tightening torque | 1.8 Nm |
Follow-up work
- Refer to INSTALLING D-PILLAR TRIM PANEL .