Preparing the special tool
- Only perform if the upper bore is not present.
- Mark and perform the bore on the special tool 0 495 484 (00 9 324) according to the specified dimensions.
Introduce the bore on the side with the long shank.
The diameter of the bore is 6 mm.
Dimension (a) = 25 mm from the center of the existing bore
Dimension (b) = 50 mm from the outer edge of the special tool
NOTE:
TECHNICAL INFORMATION
In a profile rail pair, two profile rails are connected to one another by gearing.
In a profile rail pair, two profile rails are connected to one another by gearing.
NOTE:
TECHNICAL INFORMATION
In a profile rail pair, two profile rails are connected to one another by gearing.
In a profile rail pair, two profile rails are connected to one another by gearing.
- Position the special tool 0 495 817 (31 5 251) on the special tool 2 219 012 with the help of a support person.
- Insert the special tools 0 495 821 (31 5 255) into the telescopic supports of a profile rail pair.
- Insert special tools 0 495 822 (31 5 256) into the telescopic supports of the other profile rail pair.