11 65 Charger With Control (X3 M)

11 65 TIGHTENING TORQUE OVERVIEW

Connecting brackets on exhaust turbocharger
M6	Tightening torque	8 Nm
Control rod for electric wastegate valve controller
M6 Only use an open-end wrench (for counter support) to tighten the lock nut!	tightening torque	6 ± 0.3 Nm
Electrical controller drive to exhaust turbocharger
M4 Replace screws. Tighten screws crosswise.	tightening torque	2 Nm
Exhaust turbocharger to cylinder head
M7 Observe tightening sequence! Replace nuts.	1. Joining torque	10 Nm
	1. Joining torque	10 Nm
	2. tightening torque	10 Nm
	3. Joining torque	16 Nm
	4. tightening torque	16 Nm
	5. Tightening torque	16 Nm
Heat shield to cylinder head
M8X17.5 Replace screws.	Tightening torque	10 Nm
Holder on exhaust turbocharger for cylinders 4 to 6
M6X14	Tightening torque	10 Nm
Trim strip for exhaust turbocharger on cylinder head
M7X27 10.9 Observe tightening sequence! Replace screws.	1. Joining torque	20 Nm
M7X27 10.9 Observe tightening sequence! Replace screws.	2. Angle of rotation	90°