Installing the cover panel on the windscreen
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: 51 00... NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Clean the adhesive area of the windshield and pretreat with Sika activator -205.
The Sika activator -205 must not get onto adhesive area of adhesive bead.
Adhesive
Aktivator - 205 250 ml, Bottle 83190030155 - Adhere to the air drying time of 1 min at least.
- Reposition the lever (1) and open the special tool 0 496 529 (51 3 320)
- Detach protective film (2) in stages from adhesive tape.
- Replace the cover (1).
Parts: cover panel
- Insert the cover (1) into the guide pulleys (3).
- Place the special tool with the pressure rollers (1) up against the window edge.
- Align the cover panel on the outer edge of the window glass.
- Fit the cover and visually check for perfect fit.
- Move the lever (1) in the arrow direction and close the special tool.
- Make sure the cover (3) fits correctly in the guide pulleys (2).
- Continue to detach protective film (1) in stages from adhesive tape.
- Use the handwheel to move the special tool over the entire upper edge of the window glass.