Installing the holder with the rubber mount
- Insert and install the holder (3).
- Tighten the screws (1) and (2) hand-tight.
- Lower jack.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Holder to front axle support | ||
|---|---|---|
| M12 | Tightening torque | 100 Nm |
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder to oil pan | ||
|---|---|---|
| M12 | Tightening torque | 100 Nm |
Follow-up work
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .