Removing heat shield at upper exhaust turbocharger

WARNING: Hot surfaces .
Risk of burning!

Keep the following tool ready:
- Torque wrench (1)
- Special tool 5A19557 (2)
- Ring wrench insert (3)
Courtesy of BMW OF NORTH AMERICA, INC.
Release union nut (1) from the pressure line using special tool 5 A19 557 .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1) .
Feed out coolant line (2) from the holder (3) and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1) .
Release screws (2) .

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1) .
Feed out and remove the heat shield (2) .

Courtesy of BMW OF NORTH AMERICA, INC.