Remove the engine bridge
CAUTION:
Heavy component
.
Heavy components can lead to injury or damage .
Heavy components can lead to injury or damage .
- Remove and install heavy components with the aid of another person/other persons.
- Detach the spindle screw (1) from the engine bridge.
- Unscrew the leg screws (2) and (3).
- Guide the engine bridge out of the vehicle with the help of another person and remove.
- Unscrew the bolts (1) of the special tool 2 459 012 .
- Feed out the special tool 2 459 012
at the cylinder head and remove.
- Tighten the screw (1) of the hood catch.TIGHTENING TORQUE SPECIFICATIONS
Cross connection on support for cross connection M6x20 Tightening torque 12 Nm - Tighten the screw (1) of the hood catch.
TIGHTENING TORQUE SPECIFICATIONS
| Cross connection on support for cross connection | ||
| M6x20 | Tightening torque | 12 Nm |
Follow-up work
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .