Replace cylinder head gasket
NOTE:
RISK OF DAMAGE
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .
Damage to the surface .
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage .
- Do not use any metal-cutting tools.
- Remove oil and dirt residue from the blind holes (1) .
- Check the lining sleeves (1)
for secure fit and damage.
- Identify the cylinder head gasket (1)
using the part number.NOTE: If the cylinder head is reworked, then a 0.3 mm thicker seal is available for the service.
- Replace the cylinder head gasket.
Parts: Cylinder head gasket
- Thread in cylinder head gasket (1) and install.
- Make sure that the cylinder head gasket (1) is installed correctly in the fitting sleeves (2) .