Install brake caliper in the rear
- Fit and tighten brake hose (2)
on brake caliper.TIGHTENING TORQUE SPECIFICATIONS
Brake hose to brake caliper, rear Tightening torque 24 Nm - Make sure that the brake hose (2)
is not twisted and is not resting on the components attached to the body.
- Hook the brake hose (2) in the holders (1) .
- Position and tighten the union screw (1) , if necessary use the square end (2) for counter support.
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR BRAKE FLUID .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .