Install front brake caliper
- Fit and tighten brake hose (1)
on brake caliper.
If necessary, grip at knurling (2) .
TIGHTENING TORQUE SPECIFICATIONSBrake hose to brake caliper, front Tightening torque 24 Nm - Make sure that the brake hose is not twisted and does not rest against the components fixed to the body.
Follow-up work
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to GREASE THE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER USING BRAKE PAD PASTE (17 INCH BRAKE) .
- Refer to INSTALLING THE FRONT BRAKE PADS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT OR RIGHT WHEEL .
- Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR BRAKE FLUID .