Install the rear trim seal
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Remove adhesive residue on the rear trim and clean the adhesive area (2) with solvent cleaner R2.
- Replace the seal (1)
.
Parts: Seal
- Connect the seal (1) on the rear trim (3) .
- Pull the liner* off of the adhesive strip.
* The liner is the protective film on a new seal.
- Press the seal (1)
in the adhesive area (2)
onto the rear trim (3)
.
Follow-up work
- Refer to INSTALLING THE REAR TRIM .
- Refer to INSTALLING THE TAILGATE BUTTON .
- Refer to INSTALLING THE TAILGATE TRIM PANEL .
- Refer to MOUNTING BOTH TRIM PIECES FOR THE REAR WINDOW FRAME ON THE SIDE .
- Refer to INSTALLING THE TRIM FOR THE TOP REAR WINDOW FRAME .