Install the transfer box (VTG)

Replace the intermediate shaft (1) and the radial shaft seals in the automatic transmission if the intermediate shaft (1) gets stuck on the transfer box (VTG).

Courtesy of BMW OF NORTH AMERICA, INC.
Screw special tool 2 409 025 into the outer radial shaft seal.
Turn the screw on the special tool 2 409 025 until the outer radial shaft seal has been pulled out.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert special tool 2 411 739 into the inner radial shaft seal.

Courtesy of BMW OF NORTH AMERICA, INC.
Screw special tool 2 411 739 into the inner radial shaft seal.
Turn the screw on the special tool 2 411 739 until the inner radial shaft seal has been pulled out.

Courtesy of BMW OF NORTH AMERICA, INC.
If necessary, attach the new intermediate shaft (1) on the output flange of the automatic transmission.

Courtesy of BMW OF NORTH AMERICA, INC.
Evenly coat the inside of the output flange with about 5 g grease.
CONSUMABLE SPECIFICATION

Lubricating grease Optitemp HT 1 LF 50 g, Tube 83230417754

Courtesy of BMW OF NORTH AMERICA, INC.
Install the transfer box (VTG).
Tighten the screws (1) .

TIGHTENING TORQUE SPECIFICATIONS

Transfer box to transmission
M10	tightening torque	56 Nm

Courtesy of BMW OF NORTH AMERICA, INC.