Install clean air pipe
- Feed in clean air pipe (1) and position.
- Secure clamps (3).
- Connect and lock connector (2).
The connector (2) must engage audibly.
- Feed in clean air pipe (2) and install.
The clamp (1) must engage audibly.
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Clean air pipe to cylinder head cover | ||
|---|---|---|
| TS6x20 | tightening torque | 8 Nm |
- Connect engine ventilation line (1) on clean air pipe and lock.
Engine ventilation line (1) must engage audibly.
- Connect engine ventilation line (2) to the cylinder head cover and lock.
Engine ventilation line (2) must engage audibly.
Follow-up work
- Refer to INSTALLING THE REAR BULKHEAD .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .