Installing intake silencer housing
- Insert the intake silencer housing (5) into the rubber mounts and install it.
Intake filter housing (5) must engage audibly.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Intake silencer housing to lock bridge | ||
|---|---|---|
| M6X30 | tightening torque | 8 Nm |
- Tighten clamp (4).
TIGHTENING TORQUE SPECIFICATIONS
| Clean air pipe to intake silencer housing | ||
|---|---|---|
| cl. | tightening torque | 3 Nm |
- Connect and lock the connector (3).
The connector (3) must engage audibly.
- Insert and install the holder (1).
Follow-up work