Install the high-pressure line between the high-pressure rail and the high-pressure pump
- Feed in high pressure line (1) and position.
- Hand-tighten the union nut (2) on the rail (3).
- Hand-tighten the union nut (4) on the high pressure pump (5).
- Tighten union nut (2) on rail (3).
TIGHTENING TORQUE SPECIFICATIONS
| High pressure fuel line between the rail and the high pressure pump | ||
|---|---|---|
| M14 | tightening torque | 33 Nm |
- Tighten the union nut (4) on the high pressure pump (5).
TIGHTENING TORQUE SPECIFICATIONS
| High pressure fuel line between the rail and the high pressure pump | ||
|---|---|---|
| M14 | tightening torque | 33 Nm |
- Insert and install the sound insulation (2).
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Guide in and install the cover (1).
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to IF INSTALLED: PARTIALLY INSTALLING ENGINE VENTILATION LINE .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE BATTERY EARTH LEAD .