Install the bottom C-pillar trim panel

• Check clips (1) for damage, and replace if necessary,
• Check the clamps (2) for damage, and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the end fitting (2) through the C-pillar trim panel.
• Mount the end fitting (2) and tighten the screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  End lining to body
  Screw Replace screw.	Tightening torque	42 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the carpet correctly.
• Clip in the C-pillar trim panel on the bottom (3) with the clamps (2) and the clips (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the edge protection (1) correctly in the area of the bottom C-pillar trim.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR DOOR SILL COVER STRIP .