Installing the rear brake disc
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
NOTE:
RISK OF DAMAGE
Damage to the brake disk .
Unevenness in the contact surface can cause distortion in the brake disc!
Damage to the brake disk .
Unevenness in the contact surface can cause distortion in the brake disc!
- Thoroughly clean the contact surface of the wheel hub and remove traces of corrosion if necessary.
- Position the brake disc (2).
- Replace the screw (1).
Parts: Screw
- Position and tighten the screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Brake disc to rear wheel hub | ||
| M8 Replace screw. |
Tightening torque | 16 Nm |
- Position the brake anchor plate (1) in arrow direction.
- Replace screws (2).
Parts: Screws
- Insert screws (2) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake anchor plate to rear wheel carrier | ||
| M12 Replace screw. |
Joining torque | 30 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to GREASING BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEELS .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .