Install the lower left deformation element

• Insert the deformation element (4)  .
• Tighten down screws (3)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Deformation element to front axle support adapter
  screw	Tightening torque	11.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Vertical strut to deformation element
  Flat-head screw M6x20	Tightening torque	11.8 Nm
  Hexagon screw	Tightening torque	11.8 Nm

• Tighten the screws (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Air duct to deformation element, bottom
  M6x20 screw Replace screws	Tightening torque	8 Nm

Follow-up work 

• Refer to INSTALLING THE SUPPORT FOR THE LOWER FRONT BUMPER PANEL .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to INSTALLING TEMPERATURE SENSOR .
• Refer to PARTIALLY INSTALLING FRONT LEFT AND RIGHT WHEEL ARCH COVER .
• Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
• Refer to INSTALLING THE FRONT CENTER HOOD SEAL .
• Refer to INSTALLING HOOD SEAL ON LEFT AND RIGHT SIDES .