Installing the front emblem

NOTE: TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Remove the adhesive residues at the bumper cover and clean the adhesive area.
CONSUMABLE SPECIFICATION

Cleaning agent R2 500 ml 83190417324
Pull off the liner from the adhesive tape (2).
Position the emblem (1) over the guides (3) and press on tight.

Courtesy of BMW OF NORTH AMERICA, INC.