Partly installing the rear wheel arch trim
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Mount blind rivet (1) using special tool 0 496 521 (00 2 230)
in the wheel arch trim (2)
.
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check the clips (3) for damage and replace where required.
The clips (3) must not be damaged or missing.
- Feed in wheel arch trim (2) and engage on the clips (3).
- Mount blind rivet (1) using the special tool 0 496 521 (00 2 230)
.