Install the cross-member with torsion struts
- Insert and install the cross-member (5) .
- Thread in torsion strut (4) at right and install.
- Replace screws (3)
.
Parts: Screws
- Tighten the screws (3)
.TIGHTENING TORQUE SPECIFICATIONS
Cross-member/torsion strut on rear axle support/mount M12x48
Replace screws.Tightening torque 100 Nm Angle of rotation 90° - Guide in and install the left torsion strut (2) .
- Replace screws (1)
.
Parts: Screws
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Cross-member/torsion strut on rear axle support/mount | ||
|---|---|---|
| M12x48 Replace screws. |
Tightening torque | 100 Nm |
| Angle of rotation | 90° | |