Install the charging pressure sensor on the throttle body
- Prior to installation, apply a thin coat of lubricant to the sealing ring (1) of the charging pressure sensor.
- Insert and install the boost pressure sensor (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Boost pressure sensor to throttle body | ||
|---|---|---|
| TS5x20 | tightening torque | 5 Nm |
Follow-up work
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .