Adjusting rear lid lock
Preliminary work
- Refer to REMOVING THE LUGGAGE COMPARTMENT REMOVABLE PANEL .
- Refer to REMOVING THE LOADING EDGE TRIM .
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY GAP DIMENSIONS .
- Slacken the screws (1) until the trunk lid lock (2) is barely adjustable and centers itself.
- Close trunk lid.
- Open trunk lid.
- Tighten the screws (1).NOTE: When the trunk lid is closed, the striker must not tap or scrape against the tailgate lock.
Watch out for scratches!TIGHTENING TORQUE SPECIFICATIONSTailgate lock to body M8x20 screw Tightening torque 19 Nm
Follow-up work
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT REMOVABLE PANEL .