Installing the BMW badge at the rear
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Replace the BMW badge.
Parts: BMW badge
- Completely remove adhesive residue on the badge operation and clean the adhesive area with solvent cleaner R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Pull off the liner* from the adhesive tape (2).
* Liner is the protective film on a new MINI badge.
- Position the BMW badge (1) over the guides (3) and press on tight.