22 31 001 Replacing rubber mount for transmission mounting

Necessary preliminary work: 

• Remove BATTERY .
• Secure engine in INSTALLATION POSITION .
• Remove the left WHEEL ARCH COVER .

Removal: 

Release screws (1).

Release battery housing (2) from the bracket and remove.

Release control unit (3) from the bracket.

Detach wiring harness (4) from battery tray (5).

Remove battery tray (5).

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (2).

Release screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) in wheel arch.

Remove transmission mount.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Install transmission mount.

Tighten screw (1) in wheel arch.

Tightening torque 22 32 3AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque 22 32 2AZ .

Tighten down screws (2).

Tightening torque 22 32 1AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Install battery tray (5).

Tighten down screws (1).

Tightening torque 12 90 1AZ .

Install wiring harness (4) on the battery tray (5).

Insert control unit (3) into the bracket.

Insert battery housing (2) into the bracket.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

• Install the left WHEEL ARCH COVER .
• Install BATTERY .