24 00 018 Adjusting selector lever (AISIN F22AW)
IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in tooth meshing noises be transmitted into the passenger compartment.
Necessary preliminary tasks:
- Move selector lever into "P" position.
- Remove the INTAKE SILENCER HOUSING .
Removal:
Release screw (1).
The head piece for tolerance compensation must be easily moveable before installation.
Release ball socket (1) from ball stud.
Release the cable (2) from the support angle.
Position "P" of selector lever (1) is the rearmost locked position.
Installation:
Press in cable (2) into the support angle.
Ensure cable counter support audibly engages.
Press on ball socket (1) onto ball stud.
Tighten screw (1).
Tightening torque, refer to: 24 51 1AZ .
Required follow-up work:
- Install the INTAKE SILENCER HOUSING .