61 31 008 Removing and installing/replacing steering column switch cluster (SZL)

Attention!

Move wheels into straight-ahead position and do not alter this position during the repair work.

Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.

Necessary preliminary tasks:

Refer to REMOVING STEERING WHEEL
Refer to REMOVING STEERING COLUMN SHROUD LOWER SECTION

Removal:

Release screws (1).

Remove steering column switch cluster (2) in direction of arrow.

G09949538

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1) on steering column switch cluster (2).

G11110116

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect connector (1) to steering column switch cluster (2).

G11110116

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check neutral position of clock spring on steering column switch cluster.
Neutral position is correct only when the green or yellow mark (1) is clearly visible!

G09947071

Courtesy of BMW OF NORTH AMERICA, INC.

Install steering column switch cluster in direction of arrow.

Retain steering column switch cluster pressed firmly against the steering column.

Tighten screws (1 to 4) in the order displayed.

Tightening torque 61 31 3AZ .

G11649827

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install STEERING COLUMN SHROUD LOWER SECTION
Install STEERING WHEEL