REP-TAT-P-5111-02-F48 Install bumper panel, front

WARNING: This page is about a different car, the 2019 BMW X1, 2018 BMW X1, 2017 BMW X1, and 2016 BMW X1. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Attach the front bumper panel (1) in the support at the bottom.
Depending on the equipment specification, connect the connectors on the following components and lock and disconnect:
- Ultrasonic sensors for Park Distance Control (PDC)
- Ultrasonic sensors for the Parking Maneuvering Assistant (PMA)
- Fog lights
- Temperature sensor
Courtesy of BMW OF NORTH AMERICA, INC.
Connect the hose for the headlight cleaning system and lock.
Tilt front bumper panel (1) up and position.
Attach the front bumper panel (2) on the side.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATION

Bumper panel on side wall
Screw	Tightening torque	3Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Install wheel arch trim panel (2).

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATION

Wheel arch cover
Screw	Tightening torque	3Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the bolts (arrows) on the bottom of the front bumper panel (1).

TIGHTENING TORQUE SPECIFICATION

Bumper trim, lower
Screw	Tightening torque	2, 5Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATION

Bumper panel on air duct, top
Screw	Tightening torque	4, 6Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Install the WHEEL ARCH TRIM on the left and right
Install the SEAL FOR THE FRONT BONNET