51 47 490 Removing and installing/replacing underbody protection (front)
WARNING: This page is about a different car, the 2019 BMW X1, 2018 BMW X1, 2017 BMW X1, and 2016 BMW X1. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Picture for example purposes. There may be differences in detail in the case of other models.
Removal:
Loosen screws.
Pull forward underbody protection (1) below bumper cover (2) and remove.
Installation:
Feed in underbody protection (1) below bumper cover (2) and position at screw points.
Secure underbody protection (1) with bolts.
Tightening torque 51 71 5AZ .