Removing the spring strut holder on left and right
NOTE:
Perform the steps on the right and left side.
Loosen the output shaft from the wheel bearing
- Press brake pedal.
- Loosen the collar screw (1).
The output shaft is released from the wheel bearing.
Releasing the upper wishbone from the swivel bearing
- Loosen nut (1).
- Pull out screw (2).
- Release the upper wishbone (4) from the swivel bearing (3).
Secure the swivel bearing
- Use the special tool to fasten swivel bearing (1) 2 413 317 to the body in such a way that it does not tip outwards.
Do not allow the swivel bearing (1) to hang down from the brake hose!
Removing the spring strut holder
- Loosen nut (1).
- Remove the bolt (2).
- Loosen nut (1).
NOTE:
Counter-hold at the Torx socket.
- Release the anti-roll bar link (2) from the spring strut holder.
- Release the screw (2) from the spring strut holder (1).
NOTE:
RISK OF DAMAGE
Failure to comply with the specification.
Component damage.
Failure to comply with the specification.
Component damage.
- All specifications must be observed and complied with.
- Expand spring strut holder (1) with special tool 2 414 636 .
- Protecting the output shaft from damage with a towel is mandatory (2).
- Feed out and remove the spring strut holder (1) downward.