Removing engine ventilation line of cylinder bank 2
Preliminary work
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to PARTIALLY REMOVING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 1 TO 4 .
- Refer to PARTIALLY REMOVING THE LAMBDA OXYGEN SENSOR FOR THE CYLINDERS 5 TO 8 .
- Refer to REPLACING HOLDER OF THE DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
- Refer to REMOVING COOLANT EXPANSION TANK .
- Refer to REMOVAL OF EXPANSION TANK FOR CHARGE AIR COOLERS (PARTIAL REMOVAL) .
- Refer to REMOVING CONDUIT FROM BANK 1 .
- Refer to REMOVING THE WIRING HARNESS FROM THE CYLINDER BANK 2 .
- Refer to REMOVING THE RETAINING BRIDGE .
- Refer to PARTIALLY REMOVING TANK VENTILATION LINE OF CYLINDER BANK 2 .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Unlock the retaining clip (1) upwards using a suitable screwdriver.
- Slide engine ventilation line (2)
downwards to the side.
- Loosen screws (1) .
- Guide out engine ventilation line (2) to the top.